Unistrut

Cole Industrial and Technical Supply Company is an authorized distributor of Anvil Powerstrut channel, fittings and accessories.

GENERAL
Anvil-Strut™ channels are manufactured by a series of forming dies, or rolls, which progressively cold work the strip steel into the desired channel configuration. This method produces a cross section of uniform dimensions within a tolerance of plus or minus .015", on outside dimensions.
MATERIAL
Anvil-Strut™ channels are produced from prime structural steel covered by the following specifications.
PRE-GALVANIZED STEEL - ASTM A-653
PLAIN STEEL - ASTM A-570
ALUMINUM (Type 6063T6)- ASTM B-221
STAINLESS STEEL (Type 304 and 316)- ASTM A-240
Other materials and specifications available on request.

WELDING
Channel combinations of two or more elements are spotwelded together to form various multiple combinations. The spotwelds are spaced two or three inches on centers throughout the length of the multiple channel sections.
LENGTH INFORMATION
Anvil-Strut™ Channels are produced and stocked in 10 and 20 foot lengths with a tolerance of ± 1/8". Other lengths are available upon request.

FINISHES
All Anvil-Strut™ channels are stocked in pre-galvanized and painted supr-green. Some sizes are stocked in stainless steel, zinc dichromate, PVC coated or hot dipped galvanized. (See technical section for additional information.)
LOADING DATA
1. When calculating load at center of span, multiply uniform load from table by .5 and deflection by .8.
2. When calculating beam and column loads for aluminum, multiply by 33%.

GENERAL